Our technical support is geared to customer requirements.
In-house we offer:
- Full project management
- Design assistance
- Advice on correct material selection
- Problem solving on existing components and tooling
We work closely with several UK partner companies to provide:
- 3D modeling
- FEA analysis
- Moldflow analysis
- Rapid Prototyping
I produce draught excluders for chimneys and Tyne Valley Plastics have tooled and manufactured the handles and clamps. I’ve been really pleased with them, they have done much more than just provide a tooling and manufacturing service, but have gone the extra mile to make sure the product design and quality was right before mass producing them. They offer a friendly and flexible service, and I highly recommend them. I was advised by several individuals to get the tooling and manufacturing done in China. The first drafts of the product were not quite right and needed a bit of tweaking to ensure the design was strong enough and the appropriate type of plastic was used. It would have been much harder to do this with an overseas manufacturer and the result at the end would have been a poorer quality product and / or a waste of money.
Thank you Tyne Valley Plastics!
Sally Phillips, Cockermouth